FN9260/FN261
General Purpose Power Entry Module with Fuses
Power Entry Module with EMC- Filter FN9260/FN261

General Purpose Power Entry Module with Fuses
- Rated currents up to 10 A
- Integrated single/dual fuse holder
- Optional reduced leakage current versions (A/B type)
- Complies with IEC/EN 60601-1
- Snap-in versions (S type)
- Good attenuation performance
- NEW: Wire leads option
Features and Benefits
Exceptional conducted attenuation performance, based on chokes with high saturation resistance and excellent thermal behavior
FN9260 B versions comply with the requirements of 1MOP acc. to IEC/EN 60601-1 for creepage and clearance, leakage current and high potential testing
Versions up to 10 A are available with fuse holder for one or two fuses
Custom-specific versions are available on request
Typical Applications
Portable electrical and electronic equipment
Medical equipment
Small to medium-sized machines and household equipment
Single-phase power supplies, switch-mode power supplies
Test and measurement equipment
Technical Specifications
Maximum continuous operating voltage
250 VAC, 50/60 Hz
Operating frequency
DC to 400 Hz
Fuse holder
1 or 2 fuses (Ø5 x 20 mm) (certified to IEC 60127-6), power acceptance 1.6W @ Ta 23°C per pole for 2 fuses. 2.5W, if only 1 pole is used.
Rated currents
1 to 10 A @ 40°C max
High potential test voltage
P –> PE 2000 VAC for 2 sec (standard types)
P –> PE 2500 VAC for 2 sec (B types)
P –> N 760 VAC for 2 sec
Protection category
IP 40 according to IEC 60529
Temperature range (operation and storage)
-25°C to +85°C (25/85/21)
Design corresponding to
UL 60939-3, CSA Std C22.2 No. 8-13, IEC/EN 60939-3, GB/T15287, GB/T15288
Flammability corresponding to
Fuseholder plastic: UL 94 V-0
Inlet plastic: UL 94 V-0
Fuseholder plastic: UL 94 V-0